For more information go to:
www.Aquaglide.com
Aquaglide Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966
Assembly
1) Locate a flat, dry area with access to electrical outlet or extension cord.
2) Unroll and place the i-LOG™ on the ground next to the Supertramp™ or
Rebound™ bouncer on the side that has two D-rings located about 1/2 way up
the side of the tube.
3)
BEFORE INFLATING
inflating the i-LOG™, attach it to the Supertramp™ using
the two Interloc™ straps as shown in the diagram below.
3) Once the straps are connected,
inflate to 1.0 psi (0,069 bar)
. Check for proper
air pressure using a manometer. This will tighten the i-LOG™ to the side of the
Supertramp™ or Rebound™. Inflation times can vary by inflator, but the log
should be firm and tight when completely inflated. In hot weather, be sure to
leave room for air expansion.
DO NOT OVER-FILL
. After inflation, screw
the valve cover on tightly - be careful to align the threads of the cover to avoid
stripping.
4) Do NOT drag the i-LOG™ or any other Aquaglide® product into the water.
Carefuly carry the products into the water to prevent punctures and leaks.
Warning: Do not use an air compressor to inflate
tube. Air compressors are designed for high pressure
inflation and can cause i-LOG™ to burst if over-inflated.
Interloc™ Strap Assembly Instructions
The strap should already be attached to the i-LOG™. If not
thread one end through the loop on the end of the strap and
cinch tightly.
1) Thread the end of the Interloc™ strap through the two
D-Rings on the Supertramp™ or Rebound™, then back
through a single ring as shown in Step 1.
2) Pull all the webbing through the rings until the white arrow
of the Interloc™ logo stops at the D-ring below. Cinch
until it is tight. See Step 2 for reference.
3) Pass the end of the webbing back through the open area of
the D-Rings on top as shown in Step 3.
4) Now bring the webbing through the opening in the single
D-Ring on the Log as shown in Step 4-5, (A).
5) Fold the strap over onto the Velcro Step 4-5 (B), and place
the other velcro tab in place to lock the strap (C).
A
B
C
