B
C
Ф6 drill bit
Step 1: Position the wall profile (No 1 ) onto the bath , approximately 12-15mm from the outside bath edge , ensuring that
the side with the pre-drilled holes are facing outwards from the bath ( Diagram A).
Step 2: Level the profile with a spirit level, then mark the position using a pencil through the 3 pre-drilled screw holes in the
wall profile,drill the marked points using a 6mm masonry drill bit. Once this is done insert 3 wall plugs(No.2) (Diagram B).
NOTE
:Y
ou may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3: Secure the wall profile using 3 x ST4X30 screws (No.4) (Diagram C).
12-15mm
from bath
edge
4x30mm screws
A
D
G
F
E
