AquaCraft GP-1 ultra, Instruction Manual

Page: 7 / 8

7
strut bolt. Move or adjust the strut, taking care not to lose the
alignment of the driveshaft to the motor coupler. If needed,
you might have to re-bend this area to regain alignment.
Racing
Roostertail
Corner
Aquacraft Point
Turn
GrimRacer
Turn
150 ft
30 ft
Start/Finish
Drivers
GP-1 ULTRA HYDROPLANE RACING RULES
Boats must remain stock. Only hardware adjustments are
allowed. Sharpening and scuffi ng are legal, but changing
a prop is not. You are also allowed to paint or add decals if
you choose.
A heat race is 6 laps and typically consists of up to 6 boats
per heat. You can run as many heats per event as you like,
but 3 to 5 is typical.
To start a race, set a timer to 30 seconds. Launch the boats
and make one full clockwise lap. At the end of the lap, you
need to be on the right side of the start line and going full
speed. Being over the start line at the end of the 30 seconds
puts you in last place. Be careful not to “jump the start.”
Cutting inside a buoy AT ANY TIME will incur a 50 point
penalty per buoy.
Points structure goes like this.
1
st
place 400 pts
2
nd
place 300 pts
3
rd
place 225 pts
4
th
place 169 pts
5
th
place 125 pts
6
th
place 96 pts
In fi ve rounds you have the potential to acquire up to 2,000 pts.
Good luck and good racing. Remember to
place your racing pictures and videos on the
AquaCraft Facebook page!
Ordering Replacement Parts
To order replacement parts for the AquaCraft GP-1 Ultra
Hydroplane, use the order numbers in the replacement parts
list. Replacement parts can be purchased from your local
hobby shop or by mail order. If you need assistance locating
a dealer to purchase parts, visit www.hobbico.com and click
on “Where to buy”. If you are missing parts, contact Hobbico
Product Support at:
Phone: 217.398.8970
Fax: 217.398.7721
E-mail: productsupport@hobbico.com
Parts List
AQUB6240 Cowl
AQUB6268
Wire Drive with Prop Shaft
AQUB8763 Rudder linkage w/Control Arm
AQUB7913 Motor Coupler
AQUB9282 Turn Fin
AQUB7914 Motor Mount
AQUG7005 28-35-2200kV Inrunner Brushless Marine Motor
AQUB9548 28mm CNC Water Jacket
AQUM7003 30-Amp Water Cooled Motor Controller
AQUB8742 Rudder Support Brackets
AQUB8735 Rudder Assembly Complete
AQUB8736 Rudder
AQUB8737 Rudder
O-Ring
AQUB8738 Rudder Control Arm
AQUB9277 Transom Drain Plug
AQUB7731 31 mm Prop
AQUB9045 Water Pickup
AQUM7050 Steering Servo
AQUB7852 Drive Dog with Prop Nut
TACJ0300 Tactic TTX300 3-Channel SLT System