TM Reverse Osmosis Water Filtration System
Product Code: SYS-RO924TM5
Page
8
of
15
CARTRIDGE INSTALLATION/MAINTENANCE
To change the filter cartridges, adhere to the following procedure.
1.
Close 1/2" Tee with 1/4" Push-In Tube Connector (Mains Connector or Shut Off Valve) to prevent water flow.
2.
Relieve water pressure by operating faucet lever.
3.
Unscrew filter housing sump using the spanner wrench and discard cartridges. When removing housings place a container
underneath to catch any spillage. (See Fig 7)
Figure 7
4.
Cleanse the inside of the housing using warm water. Check O-ring and lubricate with food grade silicone lubricant or similar.
Replace O-ring if kinked or damaged (Part No: ORG-STD). (See Fig 8)
Figure 8
Figure 9
5.
Install new cartridges and
replace housing screwing them
up HAND TIGHT ONLY.
Sediment filter is on the inlet
side and chemical on the outlet
side.
6.
Reset LED indicator by
following instructions on page
10.
7.
Restore water supply & check
for leaks, rectifying any before
leaving the unit. After installing
cartridges flush unit for 5 - 10
minutes.
