TM Reverse Osmosis Water Filtration System
Product Code: SYS-RO924TM5
Page
7
of
15
9.
Reset LED indicator by following instructions on page 10.
10.
Install the drain clamp by drilling a 4 mm hole in the waste pipe. Position the drain
clamp above the trap.
Connect ¼” BLACK drain tube to drain clamp
and tighten
compression nut. Do not allow drain hose to protrude more than 10 mm into drain,
making sure the holes in the drain and the clamp are exactly aligned. This can be
done by inserting a thin Phillips screwdriver through them whilst tightening the
clamp. (Fig 5)
11.
When connecting the red, black, blue and white tubes leave plenty of extra
length so that the purifier can be repositioned during servicing without having to
disconnect all the hoses.
12.
Connect WHITE tube to storage tank.
Screw ball valve to tank outlet and ensure valve
is open. (Fig 6)
13.
Once unit has been completely plumbed it will need to be actuated. To do this ensure
isolation valve is off and faucet is open. Gradually open isolation valve to begin water
production. The first sign will be water running to drain. This is normal and then finally
product water will begin coming out faucet. This may take several minutes.
a.
At this stage close faucet. This forces product water to fill up the storage
tank. To check that water is still being produced, check water is running to
drain. This should continue for several hours until tank is full. When tank is
full, the pressure in the tank will overcome the inlet water pressure and the
shut off valve will activate, shutting off the inlet water. To check this, check if
water is running to drain. Once tank is full, no water should run to drain. To flush
system, allow tank to fill, open faucet outlet until water stops, close faucet and allow tank to fill. Check all
connections for leaks.
14.
Reverse osmosis systems produce water slowly, almost drop to drop. If the tank is empty to begin with, it will take the tank
3 to 4 hours to fill. Reverse osmosis systems product water slowly. Initially filling the tank will take 3 - 4 hours. Fill and
empty twice before drinking water from the system. This is essential in order to flush away any sterilising solution in the
membrane.
15.
Check all connections are tightened properly. Check for leaks.
16.
To dispense drinking water from the faucet, push and hold the handle down or push up for continuous operation.
17.
When the unit is in place and the water lines are installed, the unit should be run for 4 hours before the purified water is
used, on initial start up. The unit cannot be stored for more than 2 weeks without use, or damage to the membrane may
occur. Please enquire if this is the case. For a period of non-use greater than 2 days, flush for 10 minutes before use. For
non-use periods of more than 2 weeks, the cartridges may need replacing.
18.
The sediment and chemical removal filters should be replaced every 12 months. The membrane should be replaced when
water quality deteriorates or every 36 - 48 months, depending on incoming water quality. Use only genuine AquaCo
replacement cartridges and cartridges that are suitable for this appliance.
Figure 5
Figure 6
