Page - 4
INSTALLATION
WARNING - Failure to heed the following may result in
permanent injury or death.
l
RISK OF ELECTRICAL SHOCK - Disconnect all AC power
when installing or servicing this system. Follow all state, local,
and National Electrical Code(s) (provincial and Canadian
Electrical Code(s) if applicable). Use copper conductors only.
l
RISK OF ELECTRICAL SHOCK - All electrical connections
should be made by a licensed electrician or certified electrical
contractor.
CAUTION - Failure to heed the following may result in
equipment damage.
l
Improper wiring will cause damage to the equipment. Damage
resulting from improper wiring will void the unit's warranty.
l
Failure to follow instructions may result in property damage.
The PoolSync
TM
must be installed and operated as specified.
Failure to do so will void the equipment warranty.
Wiring to a PoolSync
TM
Ready Device
The unit is equipped with a four-conductor cable that will connect
to your PoolSync
TM
Ready pool equipment. The correct wiring
sequence must be followed to ensure your unit will communicate
with the PoolSync
TM
Ready products.
ChlorSync
®
Wiring
1. Turn off power to the ChlorSync
®
unit.
2. Remove the power center cover and the grommet in one of the
available openings on the bottom of the box.
3. Insert the strain relief provided with the PoolSync
TM
device.
Route the antenna wire thorough the strain relief and into the
power center.
4. There is one (1) - four position connector and two (2) - two
position connectors located on the front of the board for wiring
compatible devices. Remove the four (4) position connector by
pulling up on the black plastic body.
5. Connect the stripped end of the wires to the corresponding
terminal on the PCB connector as shown in the diagram on the
following page.
6. Verify the wires are firmly held in place by gently pulling on the
wire.
7. Replace the connector onto the PCB header pins. Be sure to
align correctly.
8. Tighten the strain relief, replace the power center cover and
restore power to the unit.
Summary of Contents for AutoPilot PoolSync
Page 2: ......
