Aqua ZL 10.5, Manual, Page: 15 / 19

AQUA Sauna Heater
E002B-23-10-12 15
(Fig 15)
1
、
Air supply vent
2 、 optional air supply vent if mechanical exhaust ventilation is used, the opening is located 50cm above
the heater
3
、
exhaust air vent
4 、 Drying vent, which is closed during heating and bathing, the sauna room can also be dried by leaving
the door open after bathing
5 、 If there is only an exhaust vent in washing room, leave an opening (MIN CM). Under the sauna door
(Mechanical ventilation is recommended)
Chapter Four: Testing and operation
1. Testing
•
Before connecting to the power supply check the sauna heater and make sure there are no flammable
items on or around the heater, please note that on the first use the elements and stones may smoke
slightly and give off a smell – please ensure the sauna cabin is well ventilated.
•
Connect to power supply, press “ “ key, temp and time windows will display data, LED shows the
sauna ’ s heating status when the light is on , the temperature of sauna room will rise and will achieve the
preset temperature (the default settings are 75
℃
/167
℉
, work time is 2 hours) chart 9
•
When the time has finished counting down and the time window displays “ 0 ” , the controller and heater
will shut down automatically.
•
“ “ : Turns sauna light on/off
•
“ “ : Turns sauna fan on/off
•
The Controller has a timing device so you can set a time when you want the heater to power up, this
can be set from 0~12 hours as shown in the
Chart 9
below. When the controller is in B Model (Timer
mode) the heater can ’ t operate, but when B Model reaches “ 0 ” or the “ ” is pressed the heating