15
L0200390
EQUO SOFT
Rev.2.2
10/11/2015
Dear Customer,
first of all we want to thank you for your confidence in purchasing our product a.
The softener you have purchased has been designed and developed using our best
technology.
This equipment is suitable for the treatment of cold water, in rooms protected from the ice
and with a maximum ambient temperature of 30 ° C.
Each product is fully checked and packed individually.
GENERAL INTRODUCTION
This Installation and use is to be considered part of the same product for the lifetime of the
product, even if transferred to third parties, until the demolition and disposal of the same. All
rights of reproduction and dissemination of this Installation and Use and the accompanying
documentation, are reserved to the manufacturer.
The purpose of this manual is to:
•
In order to get the best performance of the product, it is recommended to strictly follow the
instructions in this manual to be carefully read and understood in its entirety.
•
It is recommended to install the water softener by a professional technician.
•
Do not install the softener on a water whose temperature is above 50 ° C.
The guarantee becomes invalid if the softener freezes or if the resin is deteriorated by water
that is too hot.
•
You 'should place the softener close to a drain to discharge the water used in the
regeneration cycle as well as an overflow compartment of salt.
•
This softener can not be used to treat water microbiological quality does not comply with
the law or with unknown characteristics.
Do not plug directly into your water softener of a well, rainwater or water from a borehole
without prior treatment to conform.
In case of abnormal use of the device as mentioned above, the guarantees may not apply.In
caso di uso anomalo dell’apparecchio come citato qui sopra, le garanzie non potranno essere
applicate.
The European Directive 2002/96 / EC requires that all electrical and electronic
equipment are disposed of in accordance with the requirements on waste electrical
and electronic equipment. This directive or similar laws are in force nationally and can
vary from region to region. Please refer to provincial laws and local know the
procedures for the disposal of this equipment.
INSTALLATION REQUIREMENTS
•
Handle the softener carefully.
•
Do not install the softener under the direct sunlight or near a heat source.
•
The water softener has a maximum allowable pressure of 8 bar and a minimum of 2 bar.
•
If necessary, use a pressure reducer.
•
Power the softener alone with his 24V transformer supplied.
•
Be sure to attach the transformer and a plug is protected by a protective device against power
surges as a circuit breaker or fuse.
