Aqua Ultraviolet Classic 114, Instruction Manual, Page: 27 / 36

AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO TEMECULA CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
REPLACEMENT OF THE QUARTZ SLEEVE
7. Twist on the Quartz Cap. DO NOT use a pipe wrench, pliers or any other tool on this unit. Tighten
by hand only.
To Reinstall the Lamp
Go to step #6 under changing the Lamp on page 21.
24
5. Re-install E-Z Twist Top without Quartz Sleeve. Slide Quartz Sleeve into the housing. Be sure to
center the quartz sleeve into the seat at the bottom of the unit. Note if you have the Wiper
Option: Push the rod completely into the unit. Wet the outside of the Quartz Sleeve and insert
through the blade(s). Please note units that use 40 Watt Lamps have 2 Wiper Blades, be sure to
insert Quartz Sleeve into both Blades. Be sure the Quartz Sleeve is seated in the bottom of the UV
Body.
TM
Wiper Extended Out
1. Unplug system, turn pump off and drain housing. Remove Lamp and Transformer.
Note: If you have the Wiper option, pull the Wiper Rod out to be fully extended.
2. Untwist E-Z Twist Top. This will release the Quartz Sleeve Assembly. Pull The Quartz Sleeve
Assembly straight out of the housing.
3. Untwist Quartz Cap. Push Quartz Sleeve up through E-Z Twist Top. Be careful not to break the
Quartz Sleeve. Handling broken glass can cause injury. If your Quartz Sleeve is broken protect
your hands before servicing.
4. Discard old Quartz Sleeve and Rubber Seal, be sure to use only genunie Aqua UV Quartz Sleeves.
6. Gently push the Quartz Sleeve and Rubber Seal in to the E-Z Twist Top until only ½ the rubber
seal is visible.
Ti
gh
ten Cap
Quartz Cap
EZ Twist Top
Quartz Cap
Quartz Sleeve
Quartz Sleeve Assembly