Aqua Ultraviolet Classic 114, Instruction Manual, Page: 26 / 36

AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO TEMECULA CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
23
Unscrew Transformer Cap
Transformer Cap
Unscrew Davis Connector
4. Slide Lamp out, be careful not to slide the Lamp out at an angle, even a slight angle, this may
cause a “U” shaped crack at the end of the Quartz Sleeve, or possible breakage of the Lamp.
Set the lamp on a secure level surface to avoid breakage.
1. Unplug the UV from the power source and turn off the pump.
2. Unscrew the Davis or Hubl Connector
located behind the Transformer Cap,
this allows your Transformer Cap to
spin freely.
3. Twist off the Transformer Cap.
7. The Quartz Sleeve can be cleaned with Lime Away, CLR or similar products.
Note: Do not use any type of abrasive substance on the Quartz Sleeve as it may scratch the
quartz.
8. Once the sleeve has been cleaned, wet the Wiper Blades and the outside of the Quartz Sleeve.
Note: Use water only do not use any lubricant.
9. Push the rod completely into the unit and insert Quartz Sleeve assembly through the blade(s).
Please note units that use 40 Watt Lamps have 2 Wiper Blades, be sure to insert Quartz
Sleeve into both Blades. Be sure the Quartz Sleeve is seated in the bottom of the UV Body.
5. Pull the Wiper Rod completely out (fully extended)
10. Screw on the EZ Twist top. Do not use a pipe wrench, pliers or any other tool on this unit.
Tighten by hand only. Re-Install the lamp as shown on page 21, starting at #6.
CLEANING THE QUARTZ SLEEVE FOR WIPER UNITS
6. Twist off the large nut (E-Z Twist Top). This will release the Quartz Sleeve and the assembly
will still be intact.
EZ Twist Top
Wiper Extended Out
Rod all the way in