Aqua Ultraviolet Classic 114, Instruction Manual, Page: 25 / 36

AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO TEMECULA CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
22
CLEANING THE QUARTZ SLEEVE
4. Slide Lamp out, be careful not to slide the Lamp out at an angle, even a slight angle, this may
cause a “U” shaped crack at the end of the Quartz Sleeve, or possible breakage of the Lamp.
Set the lamp on a secure level surface to avoid breakage.
1. Unplug the UV from the power source and turn off the pump.
2. Unscrew the Davis or Hubl Connector located
behind the Transformer Cap, this allows your
Transformer Cap to spin freely.
3. Twist off the Transformer Cap.
NOTE: The Lamps and Quartz Sleeves should be handled with care. Lamps and Quartz
Sleeves are not warranted against breakage and damage.
Unscrew Transformer Cap
Transformer Cap
Unscrew Davis Connector
9. Screw on the E-Z Twist Top. Do not use a pipe wrench, pliers or any other tool on this unit.
Tighten by hand only. Re-install the Lamp as Shown on page 21, starting at #6.
Quartz Sleeve
For Units Without Wipers (for Wiper units, see page 23)
5. Remove the E-Z Twist Top. The Quartz Sleeve Assembly will come out with it. Be careful to
pull it out straight.
6. The Quartz Sleeve can be cleaned with Lime Away, CLR or similar products.
Do not use any type of abrasive substance on the Quartz Sleeve as it may scratch the Quartz.
7. Replace the rubber seal.
8. To reinstall the Quartz Sleeve, carefully insert the Quartz Sleeve into the end of the UV body.
Be sure the Quartz Sleeve is seated in the bottom of the UV Unit.