Aqua Systems AQPC-35, Installation, Operation And Maintenance Manual

Page: 5 / 20

5
SECTION III. PREPARATION
A. Major System Components
The following components comprise the R.O.
Drinking Water System. (Refer to Fig. 1, page 3 for
general system layout.)
• An R.O. Manifold assembly.
• Housings and Housing O–rings.
• A Drinking Water Holding Tank.
• A Dispensing Faucet.
• A Feed Water Saddle Valve.
• A Drain Clamp.
• Plastic Tubing and tube connectors.
• A Reverse Osmosis Membrane sealed in a
plastic bag.
• A Sediment/Carbon Prefilter, shrink wrapped.
• An Activated Carbon Post Filter, shrink
wrapped.
• Water Quality Test Kit.
• Other items necessary for installation may
include wood screws or machine screws and
nuts for mounting the manifold, or concrete
anchors for hanging on basement wall,
additional tubing or tube connectors, plastic
wire ties for organizing tubing.
Figure 1
TyPICAL AqPC-35 UNDER SINk INSTALLATION DIAGRAM
Dispensing
Faucet with
air gap
Drain clamp
Drain
(3/8" Black)
prODuct
(3/8" Blue)
rO maniFOlD
Drain
(1/4" Black)
inlet
(1/4" red)
tanK
(3/8" Yellow)
DrinKing
water
hOlDing tanK
hOlDing tanK
shutOFF ValVe
(Open position)
FeeD water
saDDle ValVe
(cold water line Only)
lOcate Drain clamp
aBOVe "p" trap
4" min
actiVateD
carBOn
pOst Filter
hOusing
reVerse
OsmOsis
memBrane
hOusing
seDiment/
carBOn
preFilter
hOusing
1
2
4
5
6
7
cOVer
3
RED
BLA
CK
YEL
LOW
IN
DRA
IN
OUT
DR
AIN
RES
TRI
CTO
R
B
L
U
E
See Page 11
Close-up of Manifold