LED FUNCTION
1. The blue light fl ashes during normal operation. When the use of fi lter
cartridge exceeds the capacity, the fl ashing blue light will turn into fl ashing
red
light.
2. Please change the fi lter cartridge and battery at the same time to reset the LED
timer
indicator.
NOTE:
It is important to reset the timer using a new battery when fi lter cartridge is replaced
to ensure correct operation.
PLUMBING THE SYSTEM AND LET
AQUA-PURE
®
WATER FLOW
1. Measure a length of white tubing, to run from mixer tap hose adaptor (8) to
outlet connection on NEP head (1). Push tubing fi rmly into all-in-one mixer tap
adaptor, ensuring it is fully seated. Push other end into the outlet on NEP head,
(ref fi g 23).
2. Measure another length of tubing to connect from the inlet connection on the
NEP head (1) to adaptor 1/4” BSP x 1/4” Tube (5) on the MFCV (3), previously
installed. Push tubing fi rmly into fi ttings.
3. Neatly fi x water tubing to cupboard walls with plastic clips and screws provided.
4. Turn fi lter tap to on position. Turn water supply on slowly to release any air
trapped in the system. Allow the water to run through system for 2-3 minutes to
fl ush superfi cial dust and fi nes from the system. Turn fi lter tap off.
The water may appear “milky”; this is normal and it is caused by tiny air bubbles
being expelled from the cartridge. You may fl ush water through the system until
the water appears clear, or use the system and this condition will clear itself.
The Aqua-Pure
®
water fi lter system is now ready to produce clean and
great tasting water for you and your family’s protection and enjoyment.
fi g. 23
AS/NZS 3497:1998
Lic 21119
GUIDE TO REPLACE YOUR CARTRIDGE
1. Turn water supply off. If there is no isolation tap, turn off mains water supply.
2. Turn fi lter tap on to check water supply is off and to release any residual water.
Leave fi lter tap in ON position.
3. Remove used AP9350 cartridge by turning it to the left, until the IN/
OUT
marker
aligns to the marker on NEP head (ref fi g a).
4. Hold cartridge fi rmly and pull downwards. (Be aware there will be
approximately 15ml / 1 tablespoon of water spill) (ref fi g b).
5. Drain and dispose of the used cartridge.
6. Remove red plastic cover on new AP9350 cartridge and insert into
the head cavity. Align IN/OUT marker
on cartridge to the marker
on NEP head (ref fi g c).
7. Turn cartridge to the right, until the LOCK marker
on cartridge
aligns to the marker on NEP head. (ref fi g d)
8. Slowly turn water supply on. Leave fi lter tap at ON position and allow water to run
for 2-3 minutes to fl ush the new cartridge.
NOTE:
Aqua-Pure
®
fi lter systems are designed for ease of installation. However, post-installation
inspections are highly recommended. Check for leaks immediately after installation and once
again after 24 hours. If leaks are detected, turn off water supply, drain water and inspect the
leaks. If problem persists, contact the installer/ plumber for rectifi cation.
TREATMENT AND TESTS TABLE C1
This appliance meets the domestic water treatment appliance Standards AS/NZS
3497 and AS/NZS 4348 for the following water treatment process.
Class Treatment Type
Function
Pass
I
Microbiological Status
Will stop bacteria increasing, but will
n/a
Bacteriostatic
not remove them unless II (a) is ticked
II Microbiological
Treatment
II (a)
Bacteria Removal
Will remove inactive bacteria
n/a
II (b)
Virus Removal
Will remove inactive virus
n/a
II (c)
Protozoa Removal
Will remove inactive Cryptosporidium
and
Giardia
III
Turbidity & Particulate
Will reduce cloudiness
Reduction
IV
Taste & Odour Reduction
Will reduce taste and odour
V
Chemical Treatment
Will decrease chlorine compounds
Legend
= Pass Test
N/A = Not applicable
NOTE:
The use of this appliance may increase the bacterial content of the water unless
supplementary treatment is provided.
a.
b.
c.
d.
3 YEAR WARRANTY & CARTRIDGE
REPLACEMENT PROGRAM
Register online at
www.aquapure.com.au/warranty
or post this warranty registration card back to us
1. We will keep your warranty registered and safe on your behalf
2. We will send you an annual replacement cartridge reminder
notifi
cation
WATER FILTERS
Warranty Registration Card
This warranty registration section must be completed
and posted within 14 days of purchase
Please print clearly
Title: Miss / Ms / Mrs / Mr or other, please specify
(please circle)
Name
Address: Suburb:
State:
PCode:
Contact No:
Email:
Store name
Date of Purchase / Installation
/ /
Water Filter System
