10
www.AquaProducts.com/Service
Debris may vary due to geography, landscape or season.
Therefore, your cleaner has been equipped with the ability to
adjust the opening size of its Debris Intake Ports to accommodate
larger or smaller debris.
For smaller dirt like pine needles, sand and pollen slide the
Intake Port Width Selector (Fig. 10a), located on the inside of the
Bottom Lid Assembly, in the direction of the arrow indicating
“LESS”. This will restrict the opening ability of the Port Flaps
thus increasing its suction velocity to improve the removal of
sediment dirt.
For larger debris like leaves, twigs and acorns slide the Intake
Port Width Selector (Fig. 10b) away from LESS to increase the
Port opening size to accommodate larger dirt and debris.
Similar to a house vacuum that offers varied heights to clean
carpet and hard floors separately, your pool cleaner is equipped
with the patented Variable Intake Port Depth Extensions. There
are 2 pairs provided, each of different thickness / depths,
offering varied depth suction points to access different types of
dirt from different types of pool surfaces.
Use either the thicker pair to access heavy dirt like sand, algae or
silt embedded in porous surfaces like gunite, plaster or pebbled
textures or the thinner pair to access lighter dirt like pollen and
dust in less porous surfaces like vinyl liners. You may even
use one of each of the Port Depth Extension thicknesses to
provide varied dirt accessibility or use none at all and allow the
cleaner’s standard suction depth of the Bottom Lid Assembly
to do the job should your pool surface be virtually porous-free
like fiberglass.
To install simply align each Variable Port Depth Extension
1.
tab to fit into its corresponding receptacle in the Bottom Lid
Assembly. Be sure that the angled side of each “Extension”
is facing the nearest Brushes (Fig. 11).
Figure 10a
Figure 10b
Figure 11
Figure 12
Two NeverStuck™ Rollers (Fig. 12) are located adjacent to the
Vacuum Intake Ports (Figure 11) on the Bottom Lid Assembly.
These help prevent the cleaner from being stuck on obstacles
like raised drain covers , convex lights or in-floor pop-up
heads. If they are not needed, the rollers my be removed with
a phillips head screwdriver.
DEBRIS INTAKE PORT WIDTH SELECTOR (Page 4; Fig. 3b)
Selector moved
toward LESS
Selector moved
away from LESS
VARIABLE INTAKE PORT DEPTH EXTENSIONS
(Page 4; Fig. 3b)
NEVERSTUCK
™
ROLLERS (Page 4; Fig. 3b)
POWER WASHING JET SYSTEM
Some models come equipped with the Power Wash Hydroscrubbing Jet system (Fig. 13). An internal centrifugal pump
produces two pressurized streams of water that help dislodge dirt like sand from seams, pores and corners where brushes
can’t reach. Periodically check the Power Washing Tubes (Fig. 13) to make sure that they are not clogged.
Close up of Power Wash
exit port after removal of
the Bottom Lid Assembly
and Filter Screen.
Figure 13