How to charge the BA
TTER
Y
How to charge the BA
TTER
Y
CAUTION
•
Only charge the battery in a well ventilated place and ensure that there is enough room to dissipate
the gas arising from charging. The venting plug must be opened when charging the battery and always
allow at least one minute for the gas to dissipate after the venting plug is opened prior to removing or
attaching the custom-made charging plug
•
Always plug the custom-made charging plug into the battery compartment first then plug into the main
power supply. Upon completion of charging, unplug the main power first then the charging plug.
•
Always ensure the charger and the plug are in dry conditions and keep them away from water.
•
Always charge the battery until the LED indicator on the charger turns to green. If in doubt about the
battery status, always recharge the battery again to ensure the battery is fully charged prior to use.
Charging the Battery
•
The
Aqua Jet is specially designed to enable the user to replace a used up battery on the Board easily.
Users should replace and charge the battery according to the following
procedures so as to provide the best care for the product:
1. Ensure that the Aqua Jet is out of the water and placed in a dry area
2. Turn off the Main Switch
3. Turn the two latches as indicated in diagram 10
4. Hold the handle and remove the battery from the Motor Driver
diagram 10
5
5
Summary of Contents for SA 3995
Page 2: ......
