diagram 5
diagram 6
diagram 7
diagram 8
1. Attaching the Motor Unit to the Control Handle Bracket
-
Place the motor unit on a flat surface and attach the control handle bracket to the
motor unit by slotting the mounting post of the motor unit into the hole in control
handle bracket until it clicks firmly into place as indicated in diagram 5.
-
Fit the two black handles firmly into place as indicated in diagram 6.
-
Pull out the safety switch on the side of the motor driver to the ‘ON’ position as
indicated in diagram 7.
-
The motor cannot be started unless the safety switch is in the ‘ON’ position. The
safety switch should always be placed in the ‘OFF’ position when attaching or
removing the control bracket handle as indicated in diagram 7.
2. Using the Aqua Jet
-
Prior to using the Aqua Jet, ensure that the control bracket mechanism and
propeller are clean and free from obstructions.
-
Your Aqua Jet is now ready to use - simply put it into the water, squeeze the control
trigger and away you go! For optimum performance, your body should be in a
horizontal position as you glide through the water.
3. Removing the Motor Unit from the Control Handle Bracket
-
We recommend that the motor unit remain attached to the control handle bracket
once the Aqua Jet had been assembled.
-
In case the motor unit needs to be removed for storage or transport, place the motor
unit on a flat surface and remove the control handle bracket from the motor unit by
pressing firmly on the two black plastic buttons on the mounting post and
simultaneously pulling the control handle bracket entirely away from the motor unit
as indicated in diagram 8.
Getting Started
Getting Started
4
4
ON
OFF
Summary of Contents for SA 3995
Page 2: ......
