aqua greek products Pull-Out Legrest Instructions Download Page 3

Page: 3 / 3

Revised 2/28/18

3. Orient the pull out legrest as shown below and slide the plastic guide/spacer into the chair support

tube. Tap the palstic guide/spacer with a hammer or mallet until fl ush with the end of the support

tube. The threaded hole in the bottom of the plastic guide/spacer should line up with the hole

drilled in the support tube. Install the washers and 1/4”-20 x 1/2” cap screw from underneath and

tighten until snug.

1" SQ. TUBE

PLASTIC

GUIDE/SPACER

PULL OUT LEGREST

1/4" FLAT WASHER
1/4" LOCK WASHER
1/4" X 1/2" CAP SCREW

CHAIR SUPPORT TUBE

PLASTIC GUIDE/SPACER

FLUSH WITH 2" SQ. TUBE

The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put

the pad up and down to make sure everything works smoothly.

LEGREST

STOWED

LEGREST

OUT

LEGREST

OUT & UP

SLOT

PIN

SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION

Summary of Contents for Pull-Out Legrest

Page 1: ...to the electronics NEVER use the lift with a dry pool Check entire box and all packing materials for parts Before beginning assembly read the instructions and identify parts using the gures and parts...

Page 2: ...lade screwdriver pry off the 2 square plug from the end of the 2 square tube of the seat arm 2 Drill a 9 32 hole at the location indicated in the drawing below through the bottom of the chair support...

Page 3: ...hers and 1 4 20 x 1 2 cap screw from underneath and tighten until snug drilled in the support tube Install the washers and 1 4 20 x 1 2 cap screw from underneath and tighten until snug 1 SQ TUBE PLAST...