aqua greek products Pull-Out Legrest Instructions Download Page 2

Page: 2 / 3

Revised 2/28/18

The pull out legrest assembly is designed to fi t under the chair and is installed inside the 2” square

tubing that supports the chair from underneath. To install the pull out legrest;

1. With a fl at-blade screwdriver, pry off the 2” square plug from the end of the 2” square tube of

the seat arm.

2. Drill a 9/32” hole at the location indicated in the drawing below through the bottom of the

chair support tube. Drill only through the bottom of the tube. Remove the burrs from the hole

before installing the legrest assembly.

Installation Instructions:

DRILL 9/32" HOLE

(BOTTOM OF CHAIR SUPPORT TUBE)

(SEE FIGURE TO THE RIGHT)

3/4"

DRILL 9/32"

(THIS SIDE)

2" SQUARE

PLUG

SEAT

SEAT ARM

Summary of Contents for Pull-Out Legrest

Page 1: ...to the electronics NEVER use the lift with a dry pool Check entire box and all packing materials for parts Before beginning assembly read the instructions and identify parts using the gures and parts...

Page 2: ...lade screwdriver pry off the 2 square plug from the end of the 2 square tube of the seat arm 2 Drill a 9 32 hole at the location indicated in the drawing below through the bottom of the chair support...

Page 3: ...hers and 1 4 20 x 1 2 cap screw from underneath and tighten until snug drilled in the support tube Install the washers and 1 4 20 x 1 2 cap screw from underneath and tighten until snug 1 SQ TUBE PLAST...