AQUA FORTE INVERSMART, Manual

Page: 93 / 120

3
2.
Attention
1.
Please read the following instructions before installation, use and maintenance.
2.
Installation must be done by professional staff only in accordance with this manual.
3.
A leakage test must be performed after installation.
4.
Please don’t stack substances, which will block air flow near inlet or outlet area, otherwise the
efficiency of the heat pump will be reduced or even stopped.
5.
Set proper temperature in order to get comfortable water temperature to avoid overheating or
overcooling.
6.
In order to optimize the heating effect, please install heat preservation insulation on pipes between
swimming pool and the heat pump, and please use a recommended cover on the swimming pool.
7.
Connecting pipes of the swimming pool and the heat pump should be ≤10m.
8.
Except for the methods recommended by the manufacturer, do not use any methods to accelerate
the defrosting process or clean the frosted parts.
9.
If a repair is required, please contact the nearest after-sales service center. The repair process must
be strictly in accordance with manual. All repair practice by non-professional is prohibited.
10.
Don’t use or stock combustible gas or liquid such as thinners, paint and fuel to avoid fire.
3.
Safety
g.
Please keep the main power supply switch far away from the children.
h.
When a power cut happens during operating, and later the power is restored, the heat pump will start
up.
i.
Please switch off the main power supply in lightening and storm weather to prevent from machine
damage that caused by lightning.
j.
Safety inspection must be carried before the maintenance or repair for heat pumps with R32 gas in
order to minimize the risk.
k.
Installation and any repairing should be conducted in the area with good ventilation. The ignition
source is prohibited during the operation.
l.
If R32 gas leaks during the installation process, all operations must be stopped immediately and call
the service center.