3
PRO SPA 60 ASSEMBLY
1. Remove tie-wraps and bubble packing from electric actuator.
2. Slide the chair arm up until the actuator bracket is about even with the actuator lug.
3. Align the holes in the actuator lug with the hole in the actuator bracket. Attach the
actuator to the actuator bracket using one (1) 3/8” x 1-1/4” shoulder bolt, one (1) 5/16”
flat washer and one (1) 5/16” nylock nut as shown in
FIGURE 1
. Tighten the nut until
snug.
PRO SPA 60 WIRING: Y-CONNECTOR
The Pro Spa 60 uses two electric actuators
to lift the seat and these actuators are
wired together using a special y-connector.
The y-connector is plugged into channel 1
of the control box.
When operating properly both electric
actuators will move at the same time. If
only one actuator moves at a time there
may be a problem with the y-connector or
the electric actuator. Always make sure the
plugs are fully seated in the control box.
Summary of Contents for PRO SPA 60
Page 14: ...14 EXPLODED VIEW PRO SPA 60 ...
