Copyright © 2018 Aqua Creek Products All Rights Reserved
Revised 6/28/18
Pull-out Legrest Installation Instructions
The PULL-OUT LEGREST ASSEMBLY is designed to fit under the standard Aqua Creek chair, and
is installed inside the 2” square tubing that supports the chair from underneath. Installation is
the same for every lift, Ranger lift is shown in picture below. To install the pull-out leg-rest;
1. With a flat-blade screwdriver, pry off the 2” square plug from the end of the 2” square tube
of the seat arm.
SEE FIGURE 9.
2. Drill a 9/32” hole at the location indicated in
FIGURE 10
through the bottom of the chair
support tube. Drill only through the bottom of the tube. Remove the burrs from the hole before
installing the legrest assembly.
2" SQUARE
PLUG
SEAT ARM
SEAT
FIGURE 9
3/4"
1"
DRILL 9/32"
(THIS SIDE)
CHAIR SUPPORT TUBE
(BOTTOM VIEW)
DRILL 9/32" HOLE
(BOTTOM OF CHAIR SUPPORT TUBE)
(SEE DRAWING TO THE RIGHT)
FIGURE 10
9
