Copyright © 2018 Aqua Creek Products All Rights Reserved
Revised 6/28/18
3. Orient the pull-out legrest as shown in
FIGURE 11
and slide the
PLASTIC GUIDE/SPACER into the chair support tube. Tap the PLASTIC
GUIDE/SPACER with a hammer or mallet until fl ush with the end of
the support tube. The threaded hole in the bottom of the PLASTIC GUIDE/SPACER should line-up
with the hole drilled in the chair support tube. Install the lock washer and 1/4 -20 x 1/2 inch cap
screw from underneath and tighten until snug.
Pull-out Legrest Installation Instructions
You Will Need:
•
Flat head Screwdriver
•
Hammer / Mallet
•
5/32” Allen Wrench
PLASTIC GUIDE/SPACER
PULL-OUT LEGREST
1/4-20 X 1/2" CAP SCREW, SS
1" SQ. TUBE
1/4" LOCK WASHER, SS
CHAIR SUPPORT TUBE
PLASTIC GUIDE/SPACER
FLUSH WITH 2" SQ. TUBE
FIGURE 11
The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put
the pad up and down to make sure everything works smoothly.
LEGREST STOWED
PULL LEGREST OUT
FLIP LEGREST UP AND PIN
SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION
SLOT
PIN
10