AQUADUCT
The system is operational now. If necessary, remove the ATX start plug
from the power supply again and attach all hardware components of
the PC to the power supply unit gain.
After a running time of about 10 hours or at visible pollutions, it is ad-
visable to change the coolant once again to remove pollutions and pos-
sible production delays (e.g. oils and swarf) from the system.
11.
11.
11.
11. Mechanical
Mechanical
Mechanical
Mechanical fill level
fill level
fill level
fill level and
and
and
and flow
flow
flow
flow i
i
i
indicator
ndicator
ndicator
ndicator
All aquaduct mark III variants have a mechanical fill level- as well as a
flow indicator. These are integrated into the two lateral aluminum pro-
files.
As you have read in the chapter about filling the system, the coolant is
filled into the right profile, seen from the front. In this profile you can see
a black ball from the side. This shows you the filling level. The filling
level must be read
while the aquaduct is working
and should always be
over the middle of the profile.
In the left profile you can see a red ball which swims upwards when
switching on the aquaduct. The ball is driven up by a side-flow of the
coolant. This ball must not be visible during operation of the system.
Important:
Important:
Important:
Important: The flow indicator only shows a sufficient flow when starting
up the aquaduct. Should the flow rate decrease or the circulation be
disrupted later, the indicator does not show this. However, it is a very
good indicator whether the ball valves of the aquaduct are open and no
air is in the system.
12. Electronic
12. Electronic
12. Electronic
12. Electronic fill level and flow indicator
fill level and flow indicator
fill level and flow indicator
fill level and flow indicator (aquaduct 360
(aquaduct 360
(aquaduct 360
(aquaduct 360
XT and 720 XT)
XT and 720 XT)
XT and 720 XT)
XT and 720 XT)
The electronic flow measurement measures precisely the flow of the sys-
tem. This is shown in the display and in the aquasuite software.
Since the integrated pumps produce a corresponding flow depending
on the fill level of the aquaduct and
their control
curve, it is possible
with a special measurement to draw conclusions on the filling level of
- 22 -
Aqua Computer GmbH & Co. KG
© 2007-2009
Gelliehäuser Str. 1, 37130 Gleichen
