PRODUCT MANUAL
BAT/44892
www.aqtron.com - [email protected]
®
FREQUENTLY ASKED QUESTIONS
Q: How many jump starts can I expect from a fully charged unit before needing to be recharged?
A: Depending on the engine type and size, condition of battery, and temperature the portable power source
normally can be used 20 times before recharging.
Q: What is the ideal storage temperature of the portable power source?
A: The portable power source will operate most effectively when stored at room temperature. The unit will
also operate under below zero degree conditions, but with less cranking power. Excessive heat will accelerate
self discharge.
Q: When recharging the unit, where should I know power source is fully charged?
A: Press test button to check voltage from volt meter. If the analog indicator over 14V, battery is fully charged.
Q: How long should I charge the portable power source?
A: The portable power source should be charged for a minimum of 30 hours when first purchased. To re
-
charge with the A/C adapter, the unit should charge 4 to 6 hours for every light not lit when the test button is
pushed. The unit can be left on the wall charger continuously without damaging the unit.
Q: Can the self contained battery be recycled?
A: Yes. Please see REMOVAL AND DISPOSAL instructions.
TESTING THE BATTERY OF PORTABLE POWER SOURCE
After fully charging the battery so all red lights come on, use a 100 amp batter load tester to apply a 100 amp
load to the portable power source. For a period of 6 seconds, the voltmeter on load tester should be 9 Vdc or
higher.
BATTERY REMOVAL AND DISPOSAL INSTRUCTIONS
Contains sealed, non-spillable lead acid battery. Must be disposed of properly.
IMPORTANT :
REMOVAL AND DISPOSAL
The battery inside this portable power source is a sealed lead-acid battery. It is required by law to be removed
and recycled or disposal of properly. National, as well as, any additional local regulations must be followed.
When the battery in this product is in need of disposal, remove it according to the instructions provided
below and take it to your local recycling center for proper recycling or disposal. If you don’t have a local recy
-
cling center that handles sealed lead-acid batteries, contact your local environmental agency for instructions.
REMOVAL INSTRUCTIONS
Begin by making sure that both booster clamps are securely stored in their compartments on each side of the
portable power source.
1. Lay the portable power source front side down. On the back of the unit, locate the screws that hold the
portable power source enclosure together.
2. Remove the screws, then lift off the back lid of the portable power source enclosure.
3. On the top of the battery are two terminals, each with wires connected to them. Disconnect these wires
from the battery by removing the bolts that hold them to the battery terminals. Be careful not to touch
both the battery terminals with the tools being used to remove the bolts to prevent accidental arcing.
4. Lift the battery out of the front of the enclosure.
