12
Quality for Professionals
7.4
Attachment of the control box
Fasten the standard supplied bracket with two bolts
in the tractor cab. Stow the excess cable in the
driver's cab to avoid pinching.
TIP:
Pay attention to the angle at which you look at
the control box to be able to read the display
optimally. If necessary, bend the bracket slightly to
adjust the angle as required.
7.5
Electrical connections
The cabling is performed as follows:
Connect the standard supplied cable directly to the battery. The fuse (20 A) is on
the positive terminal of the power cable. For the 2-pin power cable, the cable
eyelet is connected to the line fuse (20 A) (no. 2) to the positive terminal, and the
other cable eyelet (no. 3) is connected to the negative terminal of the battery.
Connect the end of the cable with the plug for the module (no. 1) to the control
box.
The 4-pin cable from the control unit is also connected to the control box.
CAUTION:
If these instructions are not observed, damage may be caused to the
control box!
IMPORTANT NOTE:
For safety-related reasons, disconnect the controls after using
the implement!
No.
Meaning
1
Plug for the module
2
Positive terminal with line fuse
3
Negative terminal
Fig.: 6
Fig.: 7
