BUCKLE SIDE INSTALLATION
1.
Remove and discard the red fibre transport washer (Figure 3).
2.
Hand tighten the bolt into the vehicle or seats built in anchorage location.
3.
Adjust the swivel bracket to the desired range of motion (refer to Figure 1).
4.
Tighten the bolt to 35-40 Nm. The arm should swivel firmly without rattle.
5.
Snap fit the supplied black plastic cover into place by first inserting ~5mm into the orange rubber arm, then routing the wiring loom
per Figure 4, then pivoting down until the hooks snap into place.
RETRACTOR SIDE INSTALLATION
1.
Remove and discard the red fibre transport washer.
2.
Hand tighten the bolt into the vehicle or seats built in anchorage location.
3.
Adjust the arm to the desired angle (refer to Figure 2).
4.
Tighten the bolt to 35-40 Nm, ensuring the ALR remains aligned with the EASI-GRIP Arm.
Figure 2: Recommended Installation Angle
w
Figure 4: Recommended Wire Route
ELECTRICAL CONECTION
BUCKLE WIRING: BLUE WIRE Normally Closed
BLACK WIRE Normally Open
RED WIRE Common
MAXIMUM POWER: 2A at 12V or 1A at 24V
Figure 1: Recommended Installation Angle
w
Figure 3: Transport Washer Removal
