8
Quality for Professionals
After starting, the seeding shaft begins rotating without the fan motor for exactly one
minute.
The calibration test can be terminated at any time by pressing the seeding shaft
button or the on/off button on the control box.
If necessary, correct the seeding shaft speed and repeat the procedure.
TIP:
refer to the respective operating manual of the seed drill to find out how to
prepare the seed drill for the calibration test.
2.7 Emptying the hopper
You can begin draining the hopper by pressing and holding the seeding shaft button
for 6 seconds when the seeding shaft is powered off. After 3 seconds, the calibration
test begins (1 short beep). By pressing and holding the button for an additional 3
seconds, the module switches to drain mode - the seeding shaft turns at full speed
(short beep 2 times)
You can stop a running function at any time by pressing the blower fan button or
on/off button.
2.8 Spreading disc speed chart
This table shows you the spreading disc speed depending on your control box's
setting:
Setting 1.2
"MDS" motor speed
"UD" motor speed
2
100
50
10
300
150
20
600
300
30
900
450
40
1300
650
50
1600
800
60
1900
950
70
2250
1100
80
2600
1300
90
2800
1400
max.
3000
1500
2.9 Automatic implement shut-off
When the control box is switched on and no button is pressed and the seeding shaft
is not switched on within 1.5 hours, the control box is switched off automatically.
