Aprimatic SLIDE 230, Electrical Installation, Use And Maintenance Instructions

Page: 26 / 40

-
26
-
English
SLIDE 230 APRICODE
CONTROL UNIT
NOTES FOR MAINTENANCE TECHNICIANS 6.
Compliance with •
Machinery Directive 98/37/EC
: When you have installed the equipment, you must complete a
Declaration
of Conformity
and a
Scheduled Maintenance Plan
in compliance with the directive and then hand over copies of these
documents to the user.
Routine maintenance 6.1
You should ask the company that installs the automation to provide a scheduled maintenance plan in compliance with the
regulations for this type of equipment (for EU countries: Machinery Directive 98/37/EC).
•
We recommend that you program the maintenance cycle on the unit
(see the section Programming the paremeters)
.
When the present number of cycles is reached, the display will fl ash rapidly at start up and when you start programming the
MAN
message will appear fl ashing for approx. 3 seconds. These signals indicate that you should proceed with maintenance.
When you have completed maintenance, program a new cycle on the unit (see the section (Programming the paremeters).
The maintenance intervals and operations recommended by
Aprimatic S.p.A.
for the electrical equipment are as follows.
Operation
Average
interval
Check the ef fi ciency and adjustment of safety devices
and the anti-crush device. Check the photocells, the
detector and the safety edge.
Every 6
months
Check the ef fi ciency of the electrical equipment.
Test the ef fi ciency of the differential overload switch
protecting the unit.
Every 6
months
Check the inside of the electrical box. Clean out any
insects, dirt or dampness.
Every 6
months
Check the ef fi ciency of the remote control batteries.
Change spent batteries.
Every 6
months
Remove branches, bushes or other obstacles which
might permanently obstruct or interrupt the photocell
beam.
Every 6
months
Warning
!
Before you start any maintenance operations,
disconnect the automation from the mains
power supply using the system electrical
differential switch.
Batteries are consumables and as such are not
covered by the guarantee.
Do not throw away old batteries with household
waste. Dispose of old batteries using the old battery
containers provided at sales outlets.
INFORMATION FOR THE USER 7.
This instruction manual is an integral part of the product. The instructions and warnings must be given to the user and
then read carefully because they include important warnings for use and maintenance. The instructions must be kept and
given to all future users.
Use this equipment for the permitted uses only. All other uses constitute improper use. All improper use is forbidden and
hazardous.
Do NOT tamper with or modify the product in any way.
Perform maintenance at the recommended intervals. See the maintenance manual and schedule issued by the installer.
Keep remote control and other control units in a safe place to prevent use by children or unauthorised people.
Only suitably skilled technicians trained on the product are authorised to connect up, test, put into service, clean and maintain
this product.
In the event of any faults disconnect the operator from the mains power supply using the main switch. Do not try to repair
the main unit. Contact the installer or other specialist assistance centre. Failure to follow these instructions may result in
hazardous situations.
Warning
!
No user serviceable parts inside. Do not attempt to repair the equipment or control unit. Do not open the electrical box. In
the event of an operating fault or a mains power failure you can OPERATE THE GATE BY HAND. (For instructions, see the
operator installation manual).
Aprimatic S.p.A.
via Leonardo da Vinci, 414
40059 Villa Fontana di Medicina - Bologna - Italia
Tel. +39 051 6960711 - fax +39 051 6960722
info@aprimatic.com - www.aprimatic.com
SPACE RESERVED FOR INSTALLER
PLEASE GIVE A COPY OF THIS PAGE TO THE USER