59
use and maintenance
Sonic 50
ADJUSTING
THE VERTICAL HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
◆
Remove the front transparent screen,
see p. 51 (REMOVING THE FRONT
TRANSPARENT SCREEN).
◆
Act on the suitable screw (1) by means
of a screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
BULBS
Carefully read p. 35 (MAINTENANCE).
Before changing a bulb, position
the vehicle on the centre stand
and turn the ignition switch to
position
≈
∆
.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the
bulb, since these may cause its
overheating and consequent
breakage. If you touch the bulb with
bare hands, remove any fingerprint with
alcohol, in order to prevent it from blow-
ing.
DO NOT FORCE THE ELECTRIC CA-
BLES.
Summary of Contents for SCARABEO 50 I.E 100 4T - 2002
