102
use and maintenance
RSV 1000 TUONO R
To adjust the headlight beam:
u
Position the vehicle on the stand, see
page 56 (PLACING THE VEHICLE ON
THE STAND).
u
Working from the rear left side of the
headlight fairing, fit a short cross-headed
screwdriver to the adjuster screw (1) and
adjust as follows:
– TIGHTEN (clockwise) to raise the
beam;
– SLACKEN (anticlockwise) to lower the
beam.
u
Repeat process for the right beam.
After the adjustment:
WARNING
Make sure that the vertical adjustment
of the headlight beam is correct.
CAUTION
The headlights are also fitted with
adjuster screws (2) for horizontal beam
adjustment;
we advise against disturbing standard
setting, unless such adjustment is
mandatory in your country. Correct
b e a m h o r i z o n t a l a d j u s t m e n t i s
performed at the factory.
TAPING OF THE HEADLIGHT
If front lights are shielded with tape (for
t r a c k u s e ) , i t i s r e c o m m e n d e d t o
disconnect the front light bulb connectors
or the reflector will overheat due to lack of
air cooling.
CAUTION
S e c u r e a n d s h i e l d p r o p e r l y a n y
disconnected cables to prevent them
from hindering handlebar rotation and
becoming wet.
CAUTION
Restore all electric connections before
using the vehicle on the road.
1
2
APRum_TUONO_MY05_01_UK.book Page 102 Monday, September 26, 2005 5:15 PM
