CYCLE PARTS
5 - 14
PEGASO 650
•
Tighten the wheel shaft clamp bolts to the right.
•
Install the washer to the shaft and tighten the wheel
shaft nut.
•
Tighten the wheel shaft clamp bolts to the left.
•
Loosen the wheel shaft clamp bolts to the right.
•
Press on the front end to settle the fork legs.
•
Tighten the wheel shaft clamp bolts to the right.
•
Remove the support that upon disassembly was put
under the tyre.
•
Fit the brake calliper, tighten the screws.
•
Remove the front support stand.
•
Remove the rear support stand.
•
With pulled brake lever, press the handlebar
repeatedly, thrusting the fork downwards. In this way
the fork legs will settle properly.
•
Position the vehicle on the stand.
•
Tighten the wheel shaft clamp bolts on either side.
Summary of Contents for Pegaso 650 2005
