X
x
Y
Z
LED/ Laser Switch (x) Laser Light(Y) LED Light(Z)
9
English
OPErATiOn
WArning:
Always check that the power supply corresponds to the voltage on the rating name
plate.
SWITCH ACTION
WArning:
Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
Switch can be locked in “ON” position for ease of operator comfort during extended use. use caution when
locking tool in “ON” position and maintain a firm grasp on the tool.
Your jig saw is equipped with an “on/off” switch trigger which is operated by squeezing or releasing.
Your jig saw is also equipped with a “Lock-On” button, located on the left side of the saw's handle just
above the switch trigger. using the “Lock-On” button allows the saw to be run continuously without the
operator having to constantly apply pressure to the switch trigger.
— To start the tool, simply pull the switch trigger.
— To stop the tool, release the switch trigger.
using with the “lock-On” button:
— To start the tool and run the tool continuously, pull the switch trigger then push in the
“Lock-On” button and release the switch trigger.
— To unlock the switch, pull the switch trigger fully and release it.
wArNiNg:
If the “Lock-On” button is continuously being depressed,
the trigger cannot be released.
USING THE LASER GUIDE:
Only turn on the laser light on when the tool is on the work piece.
1. First mark the line of cut on your work piece, good side down.
2. Insert plug into power source.
3. Place the front edge of the saw foot on the work piece, turn
on the Laser Guide and align the beam with the line of cut.
4. Hold tool firmly, squeeze the trigger
and allow the tool reach desired speed.
5. Press down (keeping the saw foot flat against the work piece)
as you slowly push the saw forward keeping the Laser beam
on center with your cut line.
6. After completing the cut, Release the trigger and turn off the laser light.
WARNING:
LASER RADIATION. AVOID DIRECT EYE ExPOSuRE. DO NOT
stare
into the laser light source. Never aim light at another person or object other than the work piece. Laser light
can Damage your eyes.
WARNING:
DO NOT
use tinted glasses to enhance the laser light. Tinted glasses will reduce
overall vision for the application and interfere with the normal operation of the tool.
WARNING:
NEVER
aim the Beam at a work piece with a reflective surface. Bright shiny reflective
sheet steel or similar reflective surfaces are not recommended with laser use. Reflective surfaces could
direct the beam back toward the operator.
