Installation
General Use
F.A.Q.
Warranty
Troubleshooting
Appendix
Safety
V2.1 [2013-1-14]
7
9505 / 9505A Docking Station
Installation
The docking station accepts a male TNC
connector. Screw the antenna cable on to
the docking station and tighten securely.
IMPORTANT:
Do not exceed cable lengths outlined in
the troubleshooting section of this manual.
Keep cable splices to a minimum.
Align the pin pattern of the cord with the
receptacle and press the plug firmly in
place. Next twist the collar to “lock” the cord
in place. Next Firmly press the Power Cable
into the transformer as shown.
Common Wire Connections
Every installation is unique, and you may not need to make every accessory connection that you see outlined
on the following pages. However, the steps shown on this page are generally the most common and should
be read carefully.
IMPORTANT:
If you are in doubt about the mounting options or the connectivity at any stage of this installation, please contact an ASE
representative for assistance. They will be able to guide you through your specific installation options more clearly.
IMPORTANT:
The Lock collar on this cable should only
be tightened “finger-tight”. Do not use
pliers as this will overtightened the cable
and potential damage the connector
housing.
Connect your Phone line to the RJ-11 jack
as shown. The plug should be pressed into
the socket until an audible ‘click’ is heard,
indicating the plug is fully seated and locked
in position.
TO REMOVE:
Use your Finger to squeeze the small
plastic tab on the plug; this will “unlock”
the plug thus allowing for its removal.
Attach External Antenna
Attach Power Input Jack
(Cigarette Lighter plug also included)
Attach Analog Phone / PBX Interface
