600840-000032 Stratus ESG Installation Instructions
Rev. 1.5
Last Revised: September 22, 2016
Page 34 of 47
Figure 2: Ambient light sensor location
4.
Shine a light on the ambient light sensor. Verify that the signal percentage
increases.
5.
If you are using the 14V or 28V lighting bus: Adjust the lighting bus input to
minimum. Verify that the displayed value is 0%.
6.
If you are using the 14V or 28V lighting bus: Adjust the lighting bus input to
maximum. Verify that the displayed value is 100%.
5.4.
Altitude
1.
Enter into configuration mode on Stratus ESG.
2.
Press
FUNC
or the arrow keys to advance to the altitude diagnostic screen.
3.
Verify that the altitude displayed is correct to your geographic location.
5.5.
EMI check
NOTE
: The EMI testing shall not be performed until after the system functional ground test is
complete and passes.
Communications
(i) Cockpit intercom
Using the cockpit intercom, verify interference-free communications between the crew while
monitoring the effects of Stratus ESG.
(ii) Cabin paging
Verify that cabin paging is functioning clearly while monitoring the effects of Stratus ESG.
