3
Apollo Design Technology, Inc.
260.497.9191 •
ApolloDesign.net
Apollo LED Outdoor Profile is supplied with one u-shaped bracket
that can be mounted to any immovable surface. The mounting bracket opening
is 0.43"(11mm). The angle of the u-shaped bracket can be adjusted using the
pivot handles on the side of the fixture. It is recommended that the power cable
is installed at the top of the fixture in wet conditions to reduce the risk of water
ingress into the body. If the fixture is to be mounted vertically downwards, it is
recommended a small disk is installed above the fixture to prevent water pooling
in the back of the unit.
Mounting
Apollo LED Outdoor Profile is supplied with one 7.87"(200mm)
long IP-rated 65 barrel (suitable for 18°(120mm) lens). To remove the barrel,
gently wiggle the barrel and pull the barrel off. To reattach, gently wiggle and push
the barrel onto the fixture. Please note that there will be a different size barrel
available to be accommodate 15°(150mm) lens and larger. There is a .03"(1mm)
opening at the front of the barrel to drain condensation. This opening should be
aligned at the bottom of the fixture. To secure the barrel to the fixture, affix the
two supplied M4 x 12mm CSK stainless steel screws through the openings in the
mounting bracket.
Waterproof Barrel
