threads and dry. Add a small amount of Mist Applicator™ lube to the threads.
i. Remove the Air Cap (#2). Rinse under warm running water. Wipe, clean and dry.
j. If necessary, remove Air Distributor Plate (#5). Rinse under warm running water. Wipe clean, dry and lubricate
with Mist Applicator™ lube.
k. Reinstall the three pieces you just removed by reversing the removal procedure. Your Mist Applicator™ should be
ready for the next use. Store the Mist Applicator ™ in the holder on the Mobile Mist™ Turbo Unit.
l. The Solution nozzle (#3) can be removed for additional cleaning if necessary. Be careful. There is a Solution
nozzle gasket (#4) around the threads of the Solution nozzle. Be sure to reinstall or leakage will occur. Removal of
the Solution nozzle is not necessary on a daily basis. You should however remove it once a week and rinse under
running water. The Solution nozzle can be easily removed with an adjustable wrench or spanner. Place the tip of
your adjustable wrench or spanner on the two flat areas of the nozzle and twist anti or counter clockwise.
m. The Solution needle (#10) can also be removed for additional maintenance. To remove: Turn the Solution Flow
Screw anti or counter clockwise until it comes out of the Mist Applicator™. Be careful when removing the Solution
Flow Screw as there is a small spring (#9) around the needle. Do not lose it. This is important to the operation of the
Mist Applicator™. Set the spring aside and pull the trigger all the way back until you can grab the needle with your
finger tips and pull it out from the back of the Mist Applicator™. Once removed, rinse under warm running water,
Clean and dry. Reinstall reversing the removal procedure. NOTE:
Occasionally it is necessary to lubricate the
needle (#10) where it slides through the gland nut (#7). Simply rub a few drops of Mist Applicator™ lube around the
needle shaft and reinsert into the back of the Mist Applicator™.
