Apogee Symphony 64, User Manual, Page: 56 / 60

APOGEE ELECTRONICS
52
Symphony64 PCI card – User’s Guide
Installing the X-Symphony card
Your X-Symphony card should include the following:
• 1 X-Symphony circuit card
• 1 X-Symphony Coverplate
• 2 aluminium standoffs
• 1 plastic standoff
1 Remove the top cover of the host interface.
2 Remove the Option Card coverplate, and set aside the screws for
later use.
3 Remove the two interface circuit board screws indicated at left, and
set them aside for later use
4 Install the two aluminium standoffs in the threaded holes vacated
by the screws.
5 On the X-Symphony card, install the plastic standoff in the hole
adjacent to the multi-pin motherboard connector.
6 Insert the Port connector end of the X-Symphony card through the
host unit back panel, and carefully place the multi-pin motherboard
connector in the mating connector found on the host interface
motherboard.
7 After verifying the alignment of the multi-pin and the mating con-
nectors, firmly press down on the X-Symphony card, over the con-
nector, until the pins are completely seated in the mating connector.
8 Re-install the circuit board screws from Step 3 in the locations
indicated below.
9 Install the X-Symphony coverplate, and secure it to the host inte-
face using two screws from Step 2.
10 Replace the top cover of the host interface.
2
9
3
4
8
5
6
9