Apogee Mini-Series FireWire, User Manual, Page: 27 / 30

APOGEE ELECTRONICS
19
Mini FireWire card – User’s Guide
3. Lift off the host interface’s top and pull back the host
interface’s rear panel
The MiniMe/MiniDAC serial number is affixed to the original
rear panel. Be sure to record the serial number before
installing the new panel.
4. If installing the Mini FireWire card in a MiniMe, replace the
EPROM chip with the EPROM chip that comes with your Mini-FireWire card
• Locate the EPROM depicted in
figure 4, and note the orientation of
the semi-circular notch found at one
end of the chip.
• Using a small flat blade
screwdriver, gently pry out the
EPROM, and set it aside. To use
MiniMe with a USB card, you will
need to save this EPROM.
• Orient the semi-circular notch
of the new EPROM in the same
direction as the old, and place the
new EPROM on top of the EPROM
socket.
• Once you have verified that the
EPROM’s 8 legs are properly
inserted, press firmly on the top of
the EPROM to seat it in the socket.
Installing the Mini FireWire Card
Figure 4
Figure 3
Figure 4A