APC-3580 User Manual
47
will search for IDE devices. This allows fine-tunes the settings to allow for faster boot times. The
following configuration options are available.
ٛ
0 seconds
ٛ
5 seconds
ٛ
10 seconds
ٛ
15 seconds
ٛ
20 seconds
ٛ
25 seconds
ٛ
30 seconds
ٛ
35 seconds (Default)
The best setting to use if the onboard IDE controllers are set to a specific IDE disk drive in the AMI
BIOS is “0 seconds” and a large majority of ultra ATA hard disk drives can be detected well within “35
seconds” (the default setting).
ATA (PI) 80Pin Cable Detection [Host & Device]
When an Ultra ATA/66, an Ultra ATA/100 or an Ultra ATA/133 IDE hard disk drive is used, an
80-conductor ATA cable must be used. The 80-conductor ATA cable is plug compatible with the
standard 40-conductor ATA cable. The system must detect the presence of correct cable so that the
AMIBIOS can instruct the drive to run at the correct speed for the cable type detected.
The
ATA (PI) 80Pin Cable Detection
BIOS option determines how the IDE cable will be detected.
Host & Device
DEFAULT
Both the motherboard onboard IDE
controller and
IDE disk drive are used to detect the
type of IDE
cable used.
Host
The motherboard onboard IDE
controller detects the
type of IDE cable used.
Device
The IDE disk drive to detects the type
of IDE cable
used.
IDE Master and IDE Slave
When entering setup, BIOS auto detects the presence of IDE devices. BIOS displays the status of the
auto detected IDE devices. The following IDE devices are detected and are shown in the
IDE
Summary of Contents for APC-3580
Page 8: ...APC 3580 User Manual 8 Figure 1 2 Rear View of APC 3580 3581 Figure 1 3 System Layout ...
Page 9: ...APC 3580 User Manual 9 1 4 Chassis Dimensions Figure 1 4 Dimensions of the APC 3580 3581 ...
Page 111: ...APC 3580 User Manual 111 Figure 6 23 Sound Effects Manager ALC655 ...
Page 123: ...APC 3580 User Manual 123 The PenMount Monitor has the following functions ...