V2.7 06/2019
8. SERVICE
The VARILYMPH 12 PRO is equipped with high quality components and is subject to strict quality requirements.
Please get in contact with the SLK GmbH in case of any defects.
SLK VARILYMPH 12 PRO devices can the maintained and repaired at SLK GmbH.
To ensure the safety of the system over a long period, it must be performed at least every 2 years a safety inspection
(STK) to the system. This can be done at the company SLK or an authorized dealer.
If there are any questions please don´t hesitate to contact the SLK GmbH.
8.1 Error messages and troubleshooting
The VARILYMPH 12 PRO is programmed in a way that the function of the device is monitored by electronics during
operation. The following error messages may occur
Warning "Check for leakage": the electronics has determined that the selected target pressure could not be established.
The reason for this may be a leak in cuffs, hoses and hose connectors. Please check the connections of the hoses to the
device; please pay particular attention that the connectors are fully engaged on all four edges. The white clips on the
connector must not protrude after correct locking:
If the message does not disappear after checking of connectors, then please check also the other parts of the hose system
for leakages (watch out for hissing noises). If you can find no cause, so please contact the responsible dealer
Warning "Error 10": Here the electronics has determined that a movable component that is responsible for the filling of
the treatment sleeves, could not go to the start position. Reason for this could be storage or operation at temperatures
below 15 ° C. In this case please increase the ambient temperature. If the device has been stored at low temperatures
(eg, overnight in a car) so please wait until the device has adapted to the ambient temperature. If the warning persists,
you should contact the responsible dealer.
Should incidents other than those described here appear, so please contact the responsible dealer before operation.
