Table of Contents
© 2014 Apeks
The metal waist buckle can be mounted on either side of the waistband.
Positioning the Waist Buckle
If you would like to switch the buckle to the other side,
weave the buckle as shown. Don the WTX harness with
cylinder(s) and your normal exposure suit. Run the 2-inch
waistband through the buckle so that the buckle will be
positioned where you like.
Excess webbing may be cut with scissors and the end burned with a lighter to prevent unraveling.
NOTE:
Do not cut the excess webbing so short that you cannot enlarge it in the future to
compensate for a thicker exposure suit.
NOTE:
Do not cut the excess webbing so short that you cannot enlarge it in the future to
compensate for a thicker exposure suit.
The crotch strap is
adjusted by
moving the 2
inch webbing through the 3-bar slide near the back. The
crotch strap should be tried on and adjusted while wearing your exposure suit. The strap should be
lightly snug but not so snug as to prevent you from raising your arms above your head. Excess strapage
can be cut with scissors and the end burned with a lighter to prevent unraveling, or it can be tucked
into the elastic retainer loop.
Adjusting the Crotch Strap