www.apcoaviation.com
Figure
9-1
9.3 OPTION 2
First attach the harness to the glider, then thread the accelerator line from the top pulley
on the riser, through the pulleys (and the elasticized ring if present) on your harness and
then attach it to the supplied speed bar. To adjust the length and activation point of the
speed system, sit in the harness and ask someone to hold the riser up in a flying position.
By pulling out the end of the line protruding above the upper pulley on the riser and by
moving the knot you can adjust the speed system. The Bar should be about 10 cm ( or
closer if you have a second step) away from the front of the harness seat. This allows you
to use the full range of the speed bar if you extend your legs fully. Do not adjust the speed
system too short as this will cause the speed system to be activated permanently while
flying and could be dangerous. It is possible to fit a second step to the system if the pilot
has trouble using the full range of the speed system (second step is supplied separately).
8
Summary of Contents for Karma EVO
