APB DynaSonics
30
© 2006 APB DynaSonics – All Rights Reserved
MONO ALTERNATE OUTPUTS (x2)
Pre-Fader Source Switch
Determines if the selected signal source is derived pre or post its associated output level control.
Mono Alternate Output Level Control
This pot controls the (mono) level of the selected alternate output signals.
Left, Right, Center, Mono, Aux 9, Aux 10 Source Switches
Determines signal source to be fed to the associated alternate mono output. These are summing switches
and all selected sources mix equally together.
Main Purpose
The two mono alternate outputs provide additional level-controlled mono outputs from the console that
may be derived from any mixture of the Left, Right, Center, Mono, Aux 9 and Aux 10 outputs. These
signals may be selected pre or post their associated output fader. These Alt outputs are typically used to
provide an independently controlled Main output, or used to feed a mono-mixed signal for remote
recording. When used as a Main output, the Alt Out can either follow the House Master fader when the
Pre-Fader switch is UP, or be totally independent of the house level when the switch is in the Down
position. In either case, the associated level control still controls the final output.
Additioinally, these +4dBu balanced XLR outputs (Alt Out A and Alt Out B) are transformer isolated and
protected from external phantom voltages typically encountered when feeding broadcast camera
equipment.
STEREO RECORD (ALTERNATE) OUTPUT
Aux 9-10 Pre-Fader Switch
This switch determines if the Auxiliary 9-10 signal sources are derived pre or post their associated output
level control.
Left-Right-Center-Mono Pre-Fader Switch
This switch determines if the Left, Right, Center and Mono signal sources are derived pre or post their
associated output level control.
Left/Right, Center, Mono, Aux 9-10 Source Switches
Determines signal source to be fed to the Stereo Record output. These are summing switches and all
selected sources mix equally together.
Mute Switch with LED
This switch mutes the rear-panel outputs and illuminates the associated red LED.
Stereo Alternate Output Level Control
This pot controls the (stereo) level of this alternate output signal.
Main Purpose
The stereo alternate output provides an additional level controlled stereo output that may be derived
from any mixture of Left/Right, Center, Mono, and Auxiliary 9 (L) -10 (R) outputs. These signals may be
selected pre or post their associated output fader. This output would usually be used as an alternate or
record output but it may also be used as an output trim of any of the sourced signals.
An impedance balanced left and right 1/4” TRS connector is provided at a +4dBu operating level for the
Stereo Alternate Output. (Output Impedance = 100
Ω
Impedance Balanced).
RCA connectors are also provided for low level outputs of the stereo alternate signal to better match the
input requirements of consumer grade recording devices.
