12
Active loudspeaker set
Restore Factory Settings:
The factory defaults are shown in the RS232 commands table. In
order to restore the factory default settings, enter the following
command: “
SET RESTORE ON<CR>
”
This function can also be executed without using RS232 commands.
In that case, power off the speaker. While pushing BASS + and -
buttons on the rear panel simultaneously, power up the speaker
with the power switch. The multifunction led will be orange.
Release the BASS + and - buttons two seconds after powering up.
All factory defaults will be restored.
The SDQ5PIR can be switched to Standby mode with the IR remote
control or with the “
SET STANDBY ON<CR>
” instruction. Leaving
Standby mode can also be done with IR remote controller or the
“
SET STANDBY OFF<CR>
” instruction. If an RS232 instruction is
sent when the amplifier is in Standby mode or during power on,
and the amplifier is not ready, it will answer “
STANDBY ON<CR>
”.
Please wait until the speaker is operational (green led at the back is
lit) and resend the instruction.
When the SDQ5PIR is in standby mode, the
AUPTRG
function will
not be able to wake up the speaker.
In standby mode, the SDQ5PIR can only be activated by a “
SET
STANDBY OFF<CR>
” command, or by cycling the power switch on
the unit.
Restore Factory Settings:
Summary of Contents for SDQ5Pir
Page 1: ...SDQ5PIR Instruction manual ...
Page 2: ......
