AP Machinebouw B.V.
- 11 -
Manual AP silage cutter NP
WARNING:
Keep the filled AP silage cutter low during transport with
regard to the stability.
8
Manoeuvre the filled silage cutter to the place at which you want to put the
cut feed block,
9
Open the cutting frame and keep the lever in the same position; after the
cutting frame has opened itself the push-off system will automatically be
activated,
WARNING:
Make sure that the tractor engine is idling when the push-
off system is activated; due to the larger oil flow at higher
rpm the push-off system will be put in work too abruptly!
9a
Open the cutting frame,
10
Drive backwards slowly eventually, to avoid spilling,
(11)
Without push-off system:
Tilt the AP silage cutter forward and slowly open the cutting frame so that
the feed slides gradually from the teeth in the mixing wagon,
WARNING:
When you unload the feed at one time mixing or dose
wagon can be damaged by the weight of the feed.
12
Place the push-off system back in the start position (retracted); put the
lever in that position which is necessary to close the cutting frame.
WARNING:
Never use the AP silage cutter to slide feed blocks over the
feed passage.
5.3
Uncoupling:
Because coupling systems for front loaders, wheel loaders and telescopic loaders
are not uniform it is not possible to fully describe the action “uncoupling” in this
manual. For safety and general instructions with regard to the uncoupling of the AP
silage cutter we refer to the manual of your tractor front loader, wheel loader or
telescopic loader. We do mention some general important safety and operating
instructions:
WARNING:
Always uncouple the silage cutter on a flat surface.
WARNING:
Before driving away make sure the hydraulic hoses of the
silage cutter do not / cannot get caught behind parts of the
front loader, wheel loader or telescopic loader.
WARNING:
Lower de machine with the cutting frame almost closed,
stop the engine of the tractor, wheel loader or telescopic
