Manual AP silage cutter
FL
A
P Machinebouw B.V.
- 9 -
5
Carefully drive the AP silage block cutter into the silage. Do not insert
the tines completely in the silage but keep a 50 mm space from the
tubular frame to the silage. Push the tines or the closed bottom down
on the silage. This prevents possible bending of the tines or closed
bottom,
WARNING:
It is very important that the cutting frame is always
loaded evenly, to avoid twisting of the machine! With
regard to this follow the correct order during cutting
of the blocks : divide the width of the silage always in
an uneven number blocks to cut and keep the system
in the cutting sequence as indicated in image 4. In
this image 'A' stands for the working width of the AP
silage block cutter and 'B' for the width of the AP
silage block cutter minus a certain distance!
6
Close the cutting frame of the AP silage block cutter completely,
7
Tilt the AP silage cutter slightly back,
WARNING:
Keep the filled AP silage cutter low during transport
with regard to the stability.
8
Manoeuvre the filled AP silage block cutter to the location on which you
want to place the cut silage block,
9
Open the cutting frame completely,
10
Drive backwards slowly, to avoid spilling,
11
At the filling of an auger bucket or feed mixer :
Slightly tilt the AP silage cutter forwards and slowly open the cutting
frame so that the feed slides gradually from the tines into the mixer,
WARNING:
Never use the AP silage block cutter to slide feed
blocks over the feed passage.
