AP Expert VT-110, User Manual

Page: 69 / 84

17
System Monitoring
Topics Covered in this Chapter
▪ Monitoring Current Conditions
▪ Viewing the Current Setpoint
▪ Resetting the Daily Run Time of a Feeder
▪ Viewing the Water Consumption History
▪ Viewing Daily History Menus
▪ Resetting Daily Histories
▪ Viewing Heater Daily Run Time History
▪ Viewing the Hourly History Logs
▪ Viewing the Water Consumption History of the Last 48 Hours
▪ Viewing the Water Consumption History per Head of the Last 48 Hours
▪ Setting the Animal Age and Count
Monitoring Current Conditions
A few menus have a quick view of the current conditions when first entering into the menu.
The following menus display current conditions:
Ambient Temperature The average room temperature of the activated probe is
displayed.
Probe Temperature The current readings of each temperature probe is displayed.
Outside Temperature The current outside temperature is displayed. *Accessible if the
outside temp. probe is enabled.
Relative Humidity The current humidity level in the room is displayed. *Accessible if
the humidity probe is enabled.
Static Pressure The current static pressure is displayed. *Accessible if the static
pressure sensor is enabled.
Time & Date
The actual time and date are displayed.
Animal Age & Count Information about the animal age and count is displayed.
Viewing the Current Setpoint
Using the menu select arrow keys, navigate to Setpoint / Curve→Setpoints .
The current setpoint is displayed.
Resetting the Daily Run Time of a Feeder
1. Using the menu select arrow keys, navigate to Heater / Feeder→Reset Run Time .
890-00081 Expert VT-110 69