4. Load Cell Installation
16
PNEG-2340
Feed-Link 2
Install Load Cell and Attach to the Bin Leg
1. Place the load cell into the load cell base, lining
up the holes. Line up the holes in the side of
the load cell with the holes in the side of the
load cell base.
2. Place pins through the holes and fasten with a
cotter pin.
3. Attach load cell top bracket to the load cell by
lining up the holes on the side and fastening
with a pin and cotter pin. Make sure the tongue
on the bracket is on the inside side of the
bin leg.
NOTE: The bin leg should rest on the load cell
bracket. DO NOT drill mounting holes
too high on the leg or the bolts will be
supporting the weight of the bin rather
than the load cell bracket.
4. Fasten the load cell top bracket to the bin leg
using bolt, washer and nut through the slot in
the bracket.
5. Drill a hole into the leg through the top hole
(hole above slot) fastening to the leg using
bolts, washers and nuts included.
6. Tighten the nut on the anchor bolt.
Figure 4I Install Load Cell
Figure 4J Drill top hole through the bin leg, using top
bracket as a guide.
