4
PACCKAGE INCLUSIONS
MAIN STATION
Power Input :
available in 110V / 220V
Station Dimensions:
265(w) x 180(d) x 220 (h) mm
Weight:
3.8 Kg
Power Consumption:
600W
Temperature Range:
80°C - 380°C
Solder Capacity:
3Kg
Heating Element:
Ceramic Heater
SPECIFICATION
Specifications are subject to change without prior notice.
1 unit Station
1 pc. Ceramic Crucible
1 pc. Skimmer
1 pc. Metal Tongs
1 pc. Sponge Platform
1 pc. Aluminum Platform Sponge
1 pc. Power Cord
1 pc. Instruction Manual
9
D. Utilizing Digital Temperature Calibration
By default, the system is properly calibrated but for some cases when
a little adjustment of the solder pot temperature is required the following
procedure can be done.
1. Turn on the solder pot heating function.
2. Set to appropriate temperature you want to calibrate. Place an
external temperature meter in the melted solder.
3. The readings on the external temperature sensor should be more or
less equal to the displayed temperature. If there are large
discrepancy in the temperature reading we can re-calibrate the
temperature setting.
4. First write down the set temperature of the solder pot and the actual
temperature reading from the external temperature meter. For
example: set temperature =300
external temperature = 330
Calibration needed = -30
5. Turn off the solder pot heating Function. Simultaneously press and
hold for 5 seconds the solder pot heating function button and
the increase temperature button .
6. The Temperature Display (“1” from the control panel) . Will switch to
“000” indicating it is now in digital calibration adjustment mode. The
calibration range is from“-30” to “030” . The leading “-” sign signifies
a negative calibration number while a leading “0” signifies a positive
calibration number.
7. Use the Temperature Adjustment buttons (“3” and “4” from the
control panel) to increase or decrease the calibration number. In our
example the set temperature is 300 but the actual temperature is
350, There is need to decrease the temperature by 50 degrees.
Press the down button until we reach “-30 ”.
8. Save the value by pressing and holding the solder pot heating
function button (“2” from the control panel).
DIGITAL CALIBRATION
