6
CONTROL PANEL GUIDE
LEGEND:
1 — Actual / Set Temperature Display
2 — Hot Plate Function Button
3 — Increase Set Temperature Button
4 — Decrease Set Temperature Button
5 — Smoke Absorber ON/OFF Button
6 — Main Power Switch
7 — Sensor
1
2
3
4
5
6
Fuse
AC plug
Back Panel
7
7
IMPORTANT REMINDERS:
1. Make sure the equipment is placed on a flat stable surface.
2. Ensure all terminal connections are properly secured.
IMPORTANT:
Please refer to the
CONTROL PANEL GUIDE
page for buttons and
display panel directory.
A. Solder Pot
1. Plug the device to the main power source using the power cord
provided in the package.
2. Switch ON the device by activating the main power switch. The display
panel (“1” from the control panel guide) will show “OFF”. This
indicates that the solder pot heating function is not activated.
3. If the system's solder pot heating function is deactivated and the
actual temperature of the hot plate is above 70 degrees Celsius. The
display will alternate between showing the actual temperature of the
solder pot and the word “OFF”. This is to indicate that the solder pot
temperature is still at a relatively high temperature.
4. When the actual temperature falls below 70 degrees Celsius the
display would continuously show the message “OFF”. This indicates
that the solder pot function is turned off, and the temperature of the
solder pot has cooled to below 70 degrees Celsius.
5. To start the solder pot heating function press and hold the solder pot
activation button. (“2” from the control panel guide)
6. The display would initially show the set temperature (“1” from the
control panel guide). After a few seconds the display will switch to
displaying the actual temperature.
8. Adjust the desired set temperature by pushing the increase or
decrease set temperature buttons.(“3” and “4” of the control panel
guide.)
9. Make sure that the smoke filtering function is turned off during initial
heat up.
OPERATING GUIDELINES
